rpireboot

README

rpireboot

Raspberry Pi service to reboot system on GPIO interrupt

Installation

Download the source code:

go get -u -v github.com/ardnew/rpireboot

The install make target will compile the Go application and install+start the systemd service:

cd "$GOPATH/src/github.com/ardnew/rpireboot"
make install

The Go application will automatically configure the GPIO pin 18 as interrupt input, pull-up, and falling edge detection, but you may want to configure the pin in your Raspberry Pi configuration file (/boot/config.txt):

gpio=18=ip,pu

Configuration

To change the GPIO pin used, or its interrupt parameters, the Go application accepts command line flags (use -h for a list of what's available). You will need to modify the systemd service file (and your /boot/config.txt) accordingly.